(1) SDK application
XINGYING software supports the secondary development of SDK, which can be used on the local machine or other computers in the same IP network segment by broadcasting data.You can change the IP address in real time in the NIC Address drop-down list box. The software supports dynamic IP acquisition without restarting the software. To use the SDK function, contact technical engineers to obtain the corresponding plug-in version.
Before starting the data broadcast, it is necessary to ensure that the steps "8, data processing (11) real-time application of MarkerSet" can be realized;
When the lens is paused, click the gear button in the upper right corner of the software interface, select the option "Use SDK" under the "Network" TAB, and click "Play" after checking, the software will save this configuration, and the function will be checked by default when the software is started later.The software in the "mode" below is the default "Multicast" mode and cannot be changed (see Figure 146)."Switchable" data mode "Point mode" and "Line mode" under "Original Data", the software default "Point" mode, no special requirements, please do not change this function at will;
Close the window, then the loaded Markerset data can be broadcast to the receiving end computer through the switch, the receiving end needs to do the corresponding development to receive the data;
After the SDK option is checked, the real-time delay time and unit can be displayed in the lower left corner of the 3D view in real-time mode (as shown in Figure 147). If the SDK function is disabled, the delay time information will not be displayed, and the SDK delay time will not be displayed in real time in post-processing mode.
Last updated
