(1) Connecting myoelectricity
Myography is divided into traditional myography and domestic wireless digital myography. The wireless EMG device transmits signals wirelessly, sends the collected EMG signals in real time, and transmits them to the wireless signal receiver, displaying the EMG data and waveform in the XINGYING software.
Use "Zhiyuwei" wireless digital myograph, plug the wireless signal receiver into the computer, and power on the myograph test module. After power on, the green indicator of the myograph test module lights up;
Use the supporting software of EMG, double-click "yw-wirlesssdk.exe" to open the Wireless window, click Configure (as shown in Figure 182), select "eight-channel" for system type, "UDP" for transmission protocol, and click Scan on the right side of receiver 1 (as shown in Figure 183).After the scan is completed, the ID name of the EMG will be printed below (see Figure 184). If the EMG is not powered on, the ID information will not be printed below;
After the correct ID of the EMG device is successfully printed in the configuration, the Sensor module in Wireless will turn green (as shown in Figure 185), indicating that an EMG test module is now connected. The number of EMG test modules can be added or reduced according to the needs, and the operation of step 2 above is repeated to connect the EMG module.
Last updated
