(5) Data restoration

Click the option of "Window split - 2 Windows: Up/down" at the top of the interface, so that the main interface is divided into two upper and lower panes (see Figure 122). When the pane is selected, there will be a red border. At this time, click "View Type" to display "3D view" in one window and select "Marker XYZ Chart" in the other window (see Figure 122);

Figure 122

Select the corresponding Markerset at the top (as shown in Figure 123), and select the Marker to be seen on the right, and you can see the XYZ coordinate curve of the reflective marker in the window (as shown in Figure 123);

Data repair shortcut keys: You can use the keyboard up or down shortcut keys to select the Marker name and Segments name on the right.To select all Marker names at once, press Ctrl+A to select all marker names.

Figure 123

Check each Marker to see if there is data loss. After data loss, the chart will draw the mark of the data loss segment. The red box in the following figure indicates that there is data loss in the frame in the range (as shown in Figure 124).

Figure 124

By holding down the middle mouse button and dragging on the timeline, the part with lost data will be included (Figure 125);

Figure 125

Click the upper toolbar icon to replace the lost data. Note that if the lost data fluctuates greatly, or the number of consecutive lost frames is large, do not repair it.

Repair Marker points in MarkerSet one by one;

Click File - Save capture Data.