Analog Graphs
When using simulation charts in Live mode, please first configure the force measuring platform to ensure that it can be used normally in Live mode. To use simulation charts in Edit, please load cap data containing simulation channels and turn on the enable switch of the force measurement table in the "Force Measurement Table Parameter Settings". Note: The digital force measuring platform does not support analog charts;
Open "Analog Graphs" in the toolbar above the software.
Right click on the chart and select "Edit Page". All channels will be displayed in the "Channels" panel floating on the left.
Click on the "Channel" button in the upper left corner of the list to select/deselect all simulation channels, and enable adaptation at the bottom of the panel. If the simulation channel is unchecked, the force and torque data of this channel will not be displayed on the simulation chart.
The software defaults to a maximum of 6 channels to be added in the channel window. If you need to add more analog channels, please double click on "Maximum Number of Lines" and enter the total number of channels to be checked.
Double click on 'Page Name' to modify the simulation chart name.
Double click on "Line Width" and enter numerical values in the input box to increase/decrease the thickness of the lines in the simulation chart；
Click the+button above the simulation chart to add a simulation chart, or right-click on the Add page in the simulation chart to add a simulation chart.
If there are multiple simulation charts that need to be deleted, please select the chart above the simulation chart and right-click on the delete page to delete the simulation chart. Alternatively, click the - sign button above the simulation chart to delete the chart. At least one simulation chart must exist, that is, the last simulation chart cannot be deleted.
Last updated
