Data Record
Before recording data, it is necessary to ensure that the software has loaded the configuration file, which can be loaded through the "File -Load Calibration File" option, or a new configuration file can be generated through calibration；
Attach reflective markers to the captured object and place it in the field；
Enter the name of the data file to be collected in the "File Box" below the software interface, avoiding Chinese characters or special symbols. After confirmation, click Enter ；
After entering the file name for recording data, click the red recording button below to start recording data, and then click the button to stop recording. At this time, a pop-up window will prompt that the data has been recoreded；
After recording a set of data, the number on the right side of the "File" input box will change to 2, indicating that it is about to record the second set of data with that file name. With the file name unchanged, the number will gradually increase after each set of data is recorded;
If there are problems recording the second set of data, or for other reasons, you want to re record that set of data by changing the number to 2. At the same time, click on the "Overwrite" button on the left and click on the recording button to re record. You can also do the same for other sets of data；
When recording, XINGYING will be checked to see if there are calibration files used in the current recording directory. If there are no calibration files in the current recording directory, the last loaded calibration file will be automatically copied to the current recording directory；
Last updated
