Connection between Camera Placement and Switch
Before installing the camera, please make sure that the three-way gimbal fixed on the truss is not loose.
Connect the cameras to the three-way gimbal using the quick-release plate, then connect the three-way gimbal to the tripod or C-clamp. For easy debugging, the cameras can be arranged in the order of the IP addresses labeled on the back.
Plug the POE Separator into the RJ45 network port and DC power jack on the back of the camera; Connect each camera's POE Separator to the switch via network cable. There is no requirement for the order of the interfaces, but they cannot be connected to the LAN/NVR of the 8-port switch or the 25/26 interface of the 24-port switch.
If it is an 8-port switch, use a network cable to connect the LAN port of the switch and the network port of the computer. If there are multiple 8-port switches, use a network cable to connect the LAN port of Switch A to the NVR port of Switch B, and then connect the LAN port of Switch B to the computer.If it is a 16-port switch, use a network cable to connect the 15th or 16th port of the switch to the computer. If there are multiple 16-port switches, use a network cable to connect the 15th port of Switch A to the 16th port of Switch B, and then connect the 15th port of Switch B to the computer.After powering on the switch, wait for about 20 seconds to confirm that each camera is powered on and lit up. The digital tube directly below the camera lights up and displays the last three digits of the IP address.
Last updated
