KUNWEI

1. Digital force plates support domestic Kunwei and Aili force plates. If you are using Aili force plates, please contact our engineering team for assistance. The following configuration instructions are only for Kunwei force plates.

2. Connect the Kunwei force plate to power. Due to the default IP subnet of the Kunwei force plate being different from that of the motion capture system, you need to change the IP of the Kunwei force plate to the 10.1.1.X subnet.

3. The method for setting the IP of the Kunwei force plate is to contact Kunwei manufacturer directly. If the user chooses not to use the 10.1.1.X IP address, then please use a dual-network card host and ensure that the IP of the Kunwei force plate is correctly configured.

4. After setting the IP address of the force plate, you can enter the set IP address in the command prompt to check whether it can be pinged through. After the communication is normal, you can configure the relevant parameters of the force plate in the motion capture software. Open XINGYING -- click on the force plate menu bar -- select "Force Plate Parameter Settings", click the "+" sign to add a force plate, select the added force plate and switch it to the Kunwei type, and configure various parameters of the force plate on the right side.

5. In the "IP Address" input box, enter the IP address you have set for your force plate. For example, if the IP address of your Kunwei force plate is 10.1.1.194, then enter 10.1.1.194 in the IP address field. Enter the corresponding port number in the "Port" field. For example, if the IP address of your Kunwei force plate is 10.1.1.19X, and its port number is 888X, then enter the appropriate values accordingly. After completion, check the option "Digital Force Plate (Network)" in the "Other Configurations" of the force plate parameter settings window.

6. When you have multiple Kunwei force plates, please repeat steps 1-5 mentioned above for each force plate. Also, ensure that you correctly set the center of the force plate according to its actual placement.

7. After configuring all the parameters (16.1.2.1), close the settings window, and we can see that the force plate has been added to the coordinate system.

   

   16.1.2.1